not quite the case, fitting kits are rare as hens teeth for these bikes.
If you can get the name of the company that actually does the fitting kits for a busa, then fair play to ya!
Am about to install a set of front Brembo calipers.
They are the Brembo 4 pot, 4 pad version that I picked up second hand.
I will also change the lines to braided ones too.
I am just wondering if I should change the master cylinder too, to make a proper difference in the brakes, or will the...
I recently fitted the helibar mod to my 2002 busa, and it makes a nice difference indeed.
However, when parking or maneuvering the bike at walking pace where I need full lock on both sides, my knuckles catch the bottom of the mirror which is annoying and a little dangerous while gripping the...
Cheers
Went for the YTZ14S, so should be a bit more powerful again, its not a gel I dont think, its a sealed lead acid type.
Got it in Dublin for 78 euro, its made by Euroglobe, the Yuasa was gonna cost 145 euro, so should be ok.
Ok I have removed the "Do not remove" strip, and I dont see any electrolyte inside, so I wonder if I top it up a little with distilled water, would it help?
Or would topping up with sulphuric acid be better?
Have a Yuasa YT12A-BS in my 2002 Busa, I have owned the bike over 2 years, but I dont know if the battery is the orignal one or been replaced before I bought the bike.
It seems to be struggling to start the bike the last few times I tried it.
Bear in mind that I only ride the bike at weekends...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.