Recent content by jjstime

Looking for someone that can do a dyno tune on my Gen1 sandrail, any suggestions ? San Diego area.

Just ended up using the stock header and modifying it. Runs great but still need to get a header and dyno tuned

wish I had saw that reply back in 2013

Anyone know where to find one of these APS? JJ

The APS "Atmospheric Pressure Sensor" went bad based on the F1 light and C22 code that came up. I know this is probably the issue because I checked the voltages called out in the service manual and I had connected a vacuum hose to it while running. :banghead: Problem is I cant seem to locate...

In San diego

Two would look cool but that is twice as many bends and mounts and pipe to go from the stock header to the can. One makes it simpler. Nice setup in that picture

I am going to modify the stock header to a 4:1. Can I just use one of the stock cans?

Hi, I am building a buggy with a 2005 busa motor and need to modify the exhaust to go with a 4:1. My question is what type of exhaust can/baffle would be good to use? It needs to be short and cost effect but reliable and improve performance. Thanks, JJ

UPdate, I reconnected the orange and yellow wires for the fan relay on the fusebox and it turned the fuel pump trigger back on.

Thanks for the schematic and welcome, great site

I cut removed the wires for lights and radiator relay, now my fuel pump is not getting a signal for its relay as well as the temp meter on the display is pegged to "H" when powered on. Also trying to work from the 99-00 wiring diagrams but need them for a 05. Any ideas PS this is for a...