I pulled the carbs of my yamalama and did a little clean and rejet. It had been running poorly since last spring and around that time I bought my Gen 1 busa. So this bike got put on the back burner. But I’ve been missing riding it. So pulled the carbs, swapped out some jets, shims and pms ect...
I made a bunch of changes to my ‘06 since last time I posted. Went back to stock wheel base(removed the extensions. Installed a Brembo brake master with ‘04-‘06 R1 calipers. Stainless braided lines front and rear. Arashi Wave rotors front and rear. EBC HH pads front and rear. Removed the...
Hi, does anyone know if Factory Pro that made the evo shift kits is still in business? I emailed a few times and got no response. Also their website comes up as untrustworthy on my browser ect.
Hey all,
Little update on my ‘06. I ended up swapping out the Dual HMF High mounts for an HMF big bird. Gonna have Johnny Cheese tune it again and see what it does. The sound out of the big bird is crazy cool. The High mounts sounded great, but the Big Bird is something else. I got the Big Bird...
Anyone know the stock brake line length for Gen 1? I’m pulling off my 4-8 extensions and need to get rid of the 36” extended line. The bike is kept in off site storage, so I can’t grab a measurement and really couldn’t get an accurate one until I swap everything out, but would like to get one...
Lots done to it. ECU flash and Dyno tune by Johnny Cheese. R1 wheel swap. R1 4-pot mono-block radial front caliper and Brembo brake master cylinder. HH pads and stainless lines. Tiger Racing LSR fender, Chain Guard and undertail. 4-8” extensions set to 6”. 16/42 Vortex steel sprockets. EK ZVX3...
Hi,
I’m installing a EK zvx3 530 chain. How big should I rivet the pin heads? EK doesn’t give a spec. RK said pin should be flared to 5.55mm-5.65mm head and DiD says 5.68mm-5.99mm head. I read on a few other forums and videos to go .4mm/.5mm to .7mm over the initial measurement of the unflared...
Got the Montgomery Carbon headlight installed. I did have to trim the round mount tabs on the lower mounts flat to fit down in the headlight spot. So the bottom 2 mounts have a flat spot on the outer edges so they can sit down in against the inside of the nose fairing. Otherwise install/fitment...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.