Amelio
Registered
I just took my chain front and rear sprockets off to replace them........also found that the clutch pushrod seal is slightly weeping which sucks but I am not going to mess with it given what is involved to replace it.
I noticed the stock front sprocket is much thicker than the replacement JT sprocket I have......the teeth are the same width but just below the teeth the center section is a good bit thicker.
Do I need to shim out the replacement sprocket to ensure proper alignment of the chain to the rear sprocket? Or just simply replace it and that is that????
Also aluminum rear sprockets are no good........I changed just the rear sprocket about 1500 miles ago went up 3 teeth......it is worn out soo bad plus not to mention 2 teeth are broke off! I bought steelr JT sprockets to replace them
I noticed the stock front sprocket is much thicker than the replacement JT sprocket I have......the teeth are the same width but just below the teeth the center section is a good bit thicker.
Do I need to shim out the replacement sprocket to ensure proper alignment of the chain to the rear sprocket? Or just simply replace it and that is that????
Also aluminum rear sprockets are no good........I changed just the rear sprocket about 1500 miles ago went up 3 teeth......it is worn out soo bad plus not to mention 2 teeth are broke off! I bought steelr JT sprockets to replace them