InfiniteReality
Registered
New arm and widened stock wheel due in tomorrow, so I'll mock it up and drop it off to powdercoaters the following day. I work on my bike in my living room and never had an issue doing anything but I know I will removing the arm with only front and rear stands.
I did a search and sounds like people use a hoist, assuming an engine hoist. Anyone forsee any issues I'd have doing it his way? Also it appears I could drop the header and use a jack to elevate and a friend to hold bike to make sure it doesnt' tip over but the header was a PITA to install. I could also borrow a motorcycle jack, but not thinking that'll work on a busa. I'm open to other suggestions as well!
Thanks for your help!
I did a search and sounds like people use a hoist, assuming an engine hoist. Anyone forsee any issues I'd have doing it his way? Also it appears I could drop the header and use a jack to elevate and a friend to hold bike to make sure it doesnt' tip over but the header was a PITA to install. I could also borrow a motorcycle jack, but not thinking that'll work on a busa. I'm open to other suggestions as well!

Thanks for your help!