07' Wiring

[teammoto]

I have a 07' Hayabusa motor with zero miles on it. I went to install it in a sandrail just like I do with the 06' and older Hayabusa's. I have had no luck in getting the fuel pump and coils to energize the triggers out of the ECU on this one. Any one have a clue what I am over looking from 2006 to 2007? I have bypassed all the safety stuff that I know of. (side-stand, tip over, 100 ohm resistor on the ign. & clutch switch. And suggestion would be great!

 

[BA BUSA]

There should be no difference in the '07 vs. '06

 

[teammoto]

This is what I have been told. But she (ECU) will not fire the coils, injectors or fuel pump... I have done many 06' and older and I have now been stumped. I have asked everyone in my industry about it and they say the same thing.. They are the same as fare as they know but they have yet to put one in so it is hard to say for sure.

 

[BA BUSA]

'02-'07 should be the same...maybe you have a pin in one of the harness conectors thats bad

 

[teammoto]

Looked it up and down. It is a 07' with zero miles. Only thing that was done to it was, pulling it out of the bike.