1400cc

[OB_turbo1300]

I will give full details about the engine once i get it dialed in and max hp is seen.

 

[OB_turbo1300]

I dynoed my new 3mm pistons and cams over the weekend with the micron pipe and power commander/yosh box. Before i broke my starter and shattered the starter cover i made 202.5 hp without dialing in the cams. I used both boxes to get the same results. with the pc2 i could smooth out the bottom alot more then with the yosh but on top end they were about the same. Hopefully next week i will dyno with the Akrapovic pipe on and mess with the cams a little. the Akr. pipe is on the same line as the yosh pipe as far quality is concern but the Akr. should make more horses then both pipe because they use a bigger pipe on the header pipes and the pipe down below. i'll keep you guys informed as i go. i'm hoping to get atleast 210 hp out of it. and this is on pump gas. And i forgot to mention that it has 118 ft-lbs of torque.

[This message has been edited by turbo1300 (edited 23 September 1999).]

 

[OB_speed]

COOL! on pump gas !! killer

Good Work!

Do you know what compression your running or can you give us that info