Neophyte
Registered
I finally managed to upload the 3D print model files, of my Gen 1 short intake stacks, to Cults3D.
They were modeled with the same inner contour as the stock short stacks but at 46mm long and a radiused bellmouth lip. I have not yet had the bike on a dyno and unfortunately, when I do go for a dyno soon, it will be with cams and slightly higher compression too.
All I could find on 3D printed stacks were guys selling (or used to sell) their 3D printed version, but no print STL files.
You can check them out at https://cults3d.com/:2041405
They were modeled with the same inner contour as the stock short stacks but at 46mm long and a radiused bellmouth lip. I have not yet had the bike on a dyno and unfortunately, when I do go for a dyno soon, it will be with cams and slightly higher compression too.
All I could find on 3D printed stacks were guys selling (or used to sell) their 3D printed version, but no print STL files.
You can check them out at https://cults3d.com/:2041405
