Coolant

[jeremy_283]

Whats the best coolant to run in these bikes?

 

[jch364]

I use engine ice and love it. it does help lower the operating temp some but it wasnt until i switched out the fan for a muzzy blade and added the lower temp switch that i really noticed the difference. Before with just the engine ice my bike would get hot at the drag strip. mostly my fault for doing hot runs. but still it got hot. real hot once. Then when i added the lower temp gauge and the muzzy blade, the needle never went past half way no matter how many runs i did back to back.

 

[PaulCav]

I used to use Engine Ice and it was a good product but not legal for drag racing, plus it can kill pets if they drink it.

Now I use Motul MoCool, it works better, is legal for racing and pets live if they are dumb enough to drink it.

See the article below:
:: DRAGBIKE.COM :: DRAGBIKE MAGAZINE :: AMA Dragbike Motul Seminar ::

 

[teddypenn]

im using engine ice now, and when its time to change ill either try something else or go back to stock. i didnt realy notice any difference.

 

[busaMD]

im using engine ice now, and when its time to change ill either try something else or go back to stock. i didnt realy notice any difference.

same here...no difference with engine ice....$40 down the drain

 

[RYC1966]

I have used 80% distilled water 20% antifreeze and the correct amount of water wetter...for a gallon or so to mix up in a container.

 

[Black Sheep]

Engine Ice here too, still gets H in traffic. Runs cooler than antifreeze, but I might look into GixerHP's double radiator mod.
Posted via Mobile Device

 

[Commuta_Busa]

this is a good option for street use if you live in areas that have <32 degree fahrenheit temps.

I have used 80% distilled water 20% antifreeze and the correct amount of water wetter...for a gallon or so to mix up in a container.