EvoTech Radiator and oil cooler guards on gen 3, Is anybody running them and do you like the fitment?
- Thread starter macon454
- Start date
-
- Tags
- radiator guards
–0——0–
Registered
I bought them. They are ok but after removing a few times for different part installs one of the welds that holds the nut broke…. I I was able to use needle nose pliers to tighten down the machine screw but it was a PITA. Not sure why they decided to make these 2 protectors bolt together as 1 unit…. As far as the material goes, it seems to be made with decent gauge metal and the fit was really good. I haven’t had a radiator puncture yet so it’s doing its job.
I have used RRG out of the UK on several bikes over the years, including my current Gsxr1k.
Their fit and finish is always perfect.
Fit both radiator sides of the guard into place, push the center, and the whole guard snaps up against the curve of the radiator.
It fits so snug that I think it would stay even without safety wiring it.
I have no Gen3 experience, but they're basically Gen2 parts anyway, I can't seem them not being as good as they are on every other bike.
Their fit and finish is always perfect.
Fit both radiator sides of the guard into place, push the center, and the whole guard snaps up against the curve of the radiator.
It fits so snug that I think it would stay even without safety wiring it.
I have no Gen3 experience, but they're basically Gen2 parts anyway, I can't seem them not being as good as they are on every other bike.
stangman327
Registered
Just found this amazing item on AliExpress. Check it out! $29.44 | Radiator Guard Engine Cooler Grille Cover Protection For Suzuki GSX1300R GSX 1300R 1300 GSX1300 R Hayabusa 2021 2022 2023 2024
Save your money and get this one from here
Save your money and get this one from here
Similar threads
