I just installed a set of RS3 bolt-ons on my 06, and I was wondering about a couple of things;
1. do the RS3 cans also need the o-rings that were on the stock can?
2. I did it cheap, & reused the stock gasket (I have less than 400 miles on the bike, so I figured I'd give it a try). I noticed a small air leak from both cans when I started the bike, but after a 20 mile ride, the leak is gone. Is this going to work for the time being until I get the new gaskets in (approx. 1 week), or should I just go ahead & park it until I get the parts in?
Sorry for the dumba$$ questions, I've just never installed aftermarket cans on a bike before (always had the stealership do it)
1. do the RS3 cans also need the o-rings that were on the stock can?
2. I did it cheap, & reused the stock gasket (I have less than 400 miles on the bike, so I figured I'd give it a try). I noticed a small air leak from both cans when I started the bike, but after a 20 mile ride, the leak is gone. Is this going to work for the time being until I get the new gaskets in (approx. 1 week), or should I just go ahead & park it until I get the parts in?
Sorry for the dumba$$ questions, I've just never installed aftermarket cans on a bike before (always had the stealership do it)