I installed the Brock’s Alien Head 2 on my 2019 Busa Friday night. I'm getting an FI error. Is that because it's new & needs to run, because the stock O2 sensor isn't on it because it doesn't fit? And is it normal for your header to smoke a little? It's smoking some on the inside of the header where the Permatex Ultra Cooper is. Instructions say put a little on the inside before you install them. It ran fine and sounded great when I ran it on Saturday. I didn't see or smell any smoke after I turned the bike off. I'm going to buy the Code C44 Eliminator Plug from Brock's and getting it flashed in a few weeks. Has anyone else experienced this & may know the answer?
FI Light after installing Brock's Alien Head 2
- Thread starter NuSkwel
- Start date
Tached1300
Registered
If the stock O2 sensor has been removed that’s why your light is on, you will need to at least have the ECU flashed to turn it off... or look into the resistor type plug etc
Similar threads
