Until this weekend I have had a microtec MT2 with 3 bar map sensor, just trying something new and different. I am a beta tester on a new plug and play megasquirt stand alone also that is an on going project, but also using the megasquirt as just a secondary injector controller at the moment.
I got it on over the weekend and made a few quick boosted pulls to see A/F, having an issue with the MS2 processor and the tach signal getting noisy when secondaries start firing, investigated some last night without any luck and tossed the MS1 processor back in and it reads perfectly, still working on that LOL.
The software is pretty cool IMO, having the palm to display everything ($20 on ebay LOL) and datalog is priceless, almost literally as well.
Once you open up the .xls file in megalog viewer you can use the VE analyzer and it will make tuning corrections to your fuel table, I only made this one pass, and A/F wasn't anywhere near perfect but at least in the ballpark LOL
You can see the cells in the upper right hand table highlighted, wherever you are on the datalog trace it will show you what cells you are using for fueling etc. Pretty neat I think.
I got it on over the weekend and made a few quick boosted pulls to see A/F, having an issue with the MS2 processor and the tach signal getting noisy when secondaries start firing, investigated some last night without any luck and tossed the MS1 processor back in and it reads perfectly, still working on that LOL.
The software is pretty cool IMO, having the palm to display everything ($20 on ebay LOL) and datalog is priceless, almost literally as well.
Once you open up the .xls file in megalog viewer you can use the VE analyzer and it will make tuning corrections to your fuel table, I only made this one pass, and A/F wasn't anywhere near perfect but at least in the ballpark LOL
You can see the cells in the upper right hand table highlighted, wherever you are on the datalog trace it will show you what cells you are using for fueling etc. Pretty neat I think.
