Flashed ecm reinstall

[WrongWheelDrive]

Just got my ecm back from Moore Mafia - is there anything you have to do or is it just plug it back in and it's good?

 

[Dustin02]

Plug it in and roll out. The warning lights on the dash will go away after 3 or 4 rides.

 

[GSXRme]

And... Disconnect your o2 sensors. If you don't have block offs for the exhaust this just disconnect them and order the bungs off of eBay/Amazon. That is a requirement!

 

[Ked0607]

definitely unplug both O2 sensors!!!

 

[sixpack577]

Disconnect the negative battery cable before removing or installing an ecu.

 

[WrongWheelDrive]

Ok so you have to completely unplug and remove both o2 sensors? I got the Alra exhaust. It came with the bungs but I took them out and put the O2 sensors in.

I emailed Chris Moore and he said just plug them ecm in and after a few rides all the lights would clear, no mention about removing the O2 sensors.

 

[MonkeyButtRides]

Ok so you have to completely unplug and remove both o2 sensors? I got the Alra exhaust. It came with the bungs but I took them out and put the O2 sensors in.

I emailed Chris Moore and he said just plug them ecm in and after a few rides all the lights would clear, no mention about removing the O2 sensors.

You do not have to remove the O2 sensors you just need to unplug them at the other end. The left side is a pain because it's under the tank. The right side is much easier to get to. You don't have to remove the side fairings, but you need to loosen them up a to make room. I believe it takes 3 key cycles and the warning lights go out.

 

[WrongWheelDrive]

You do not have to remove the O2 sensors you just need to unplug them at the other end. The left side is a pain because it's under the tank. The right side is much easier to get to. You don't have to remove the side fairings, but you need to loosen them up a to make room. I believe it takes 3 key cycles and the warning lights go out.

Awesome video thanks! Saved a lot of time instead of completely removing the plastics again.

 

[MonkeyButtRides]

Awesome video thanks! Saved a lot of time instead of completely removing the plastics again.

I didn't put this in the video, but I had to reset my RPM shift light settings. The shift light was turned off. Just a heads up you may have to reset it.

 

[WrongWheelDrive]

Ok thanks for the heads up, very much appreciated

 

[GSXRme]

Ya have fun, bikes going to feel entirely different. Peppy is the word for it.

 

[InfiniteReality]

My MM came with instructions that said to disconnect battery and unplug O2 and expect dash lights temporarily.

FYI if you find Mode A jerky in 1st gear at low speeds, try Mode B. I was willing to send my ECM back this winter to make it more stock-like during slow speeds. They replied and told me try Mode B. I did and totally happy with everything. Enjoy the tune, especially if you chose the flames & bangs!

This is through a GSXR1 stock chambered Ti muffler.