quizesilver
Registered
hi all
i run into some prob.
was doing the led gauge mod.
but some how after the mod all 4 meter is not working correctly.
the fuel gauge, i remember i had abt half tank full but it shows abt 3/4 full.
the rpm gauge, pervious setting is abt 1.2k. but now it's idle at 0rpm. it did goes up on rev but how to resolve this.
the speedo unable to check as didnt ride it.
the temp sensor was showing at 1/4 mark (between the mid and the end) and i let it idle till fan on which suppose to be at half way mark, it didnt reach there. it juz stop at there.( fan was on, thus quite sure it is suppose to be at mid point)
now i am sad i dont know what is going on.
tried the reset, but nt sure if it is working correct.
follow the steps in the manual, all meter will go to zero mark but after starting and off and start. it is back to the pervious problem..
all advise are welcome.
Thanks!
i run into some prob.
was doing the led gauge mod.
but some how after the mod all 4 meter is not working correctly.
the fuel gauge, i remember i had abt half tank full but it shows abt 3/4 full.
the rpm gauge, pervious setting is abt 1.2k. but now it's idle at 0rpm. it did goes up on rev but how to resolve this.
the speedo unable to check as didnt ride it.
the temp sensor was showing at 1/4 mark (between the mid and the end) and i let it idle till fan on which suppose to be at half way mark, it didnt reach there. it juz stop at there.( fan was on, thus quite sure it is suppose to be at mid point)
now i am sad i dont know what is going on.
tried the reset, but nt sure if it is working correct.
follow the steps in the manual, all meter will go to zero mark but after starting and off and start. it is back to the pervious problem..
all advise are welcome.
Thanks!
