Head caps ?

[Gixer]

Hi,
There was a detonation and the pressure is released caps (as shown) and the mixed water and oil.
At the head gasket on nii no damage.
Is it possible that the reason I used the stock bolts and the pressure in the air box was about 22 PSI?
Has anyone had a similar experience?

Thanks

 

[Gixer]

Hi,
There was a detonation and the pressure is released caps (as shown) and the mixed water and oil.
At the head gasket on nii no damage.
Is it possible that the reason I used the stock bolts and the pressure in the air box was about 22 PSI?
Has anyone had a similar experience?

Thanks

 

[POWERHOUSE]

Hi,
There was a detonation and the pressure is released caps (as shown) and the mixed water and oil.
At the head gasket on nii no damage.
Is it possible that the reason I used the stock bolts and the pressure in the air box was about 22 PSI?
Has anyone had a similar experience?

Thanks

#1 - yes
#2 - yes, other people who have made the same mistake
#3- it can be fixed
#4- make sure you check both the cylinder and head for straightness
#5- put studs in that thing!

 

[Gixer]

A lot of thank you very much, with me it is easier when you know the cause of the problem!

Does the APE on the bolts and nuts should be put washers?

Thanks again!

 

[texas-buzzard]

yes use the original washers.

 

[scrappy]

Or use ARP studs, those are very nice
Posted via Mobile Device

 

[Gixer]

Thanks,

I already bought the APE