Head spacer

[SxLxAxVxExN]

I've tried searching but haven't really found any useful info.
While the turbo is being installed on the bike I might as well do a head spacer just in case. Better safe then sorry. So where can I get a decent spacer from and what size? I see that boostbysmith has the .080 but I don't know if thats too much?
Any info is greatly appreciated. Thanks guys

 

[Professor]

APE Sells .040 .063 .080 .100 .125

Schnitz add .032 to the above.

Several of our sponsors sell the above or can get a few others through Cometic as well by special order.

 

[GoldenChild]

I have one in stock lmk...

 

[SxLxAxVxExN]

Which one should I get? I'm not sure what thickness to use. I plan on running around 8-10 psi safely.

 

[cdhoroho]

.08 is the typical spacer used in a turbo setup

 

[SxLxAxVxExN]

Okay so the .080 isnt too thick? I still wanna keep the bike streetable. I also found a website once where they were selling the spacer and head bolts as a kit and it was fairly cheap. Anyone know of that website?

 

[69ls1]

.080 spacer.

 

[smithabusa]

080 spacer is real common, i can get one for you if you need it, though looks like others here can get you squared away

 

[smithabusa]

i can get whatever size you want that schnitz carries, they have most of those i think, but by far turbo guys usually go 080.

Also you will need
head gasket (go cometic)
adjustable cam sprocket(s)
head studs if you want while you are already in there
could do valve springs as well if you want
lower end gasket set