Midlife III
Registered
Here is my attempt at replacing the under tail with a home made license plate bracket and LED tag bolts. The template was made out of picture matting and then transferred on to heavy duty plastic. I then cut it out on a bandsaw, drilled the holes and then put it in a vice and heated it with a heat gun and bent it to the desired angle. I had to add one more thickness at the top so the plate would clear the tail section as seen in photo. I mounted it in the rear holes from removed tail section. The wires for the LED tag bolts were run through holes that were there for alignment pins on tail section and heat shrink was added to protect it from the weather. Wires were ran up to original female connector and spliced to a new male connector given to me from a mechanic at a local shop named Motovation Cycles.
