Hmf full vs oil filter

[Bug]

Just got around to trying to install my HMF Full and noticed that it is DAMN close to the oil filter - Do those who have this system find that you need to remove the header to change the filter?

Thanks for your input - FYI, they sent me the wrong fuckin can so the bike is still in pieces and the plate for the passanger footpeg is wrong as well - It is soooo damn close to the tire that I think they sent me the wrong one

Damn exoticsportbikes.com

 

[Pipefighter248]

No need to remove the header to change oil filter.
Just get a strap wrench and it will be easy.

On the plate, are you sure you installed the spacers right?

 

[Bug]

Did what the instructions said - Plate, Spacers, Stock Plate with Peg and the way the HMF plate sits, it is damn close to the tire - They sent me the wrong can (Left side can and for a smaller exhaust, flang does not even fit over the exhaust) so I think the plate may be wrong as well

Not happy at all with exoticsportbikes or HMF at this point but I am sure I will be once it is installed and running

 

[Pipefighter248]

It is different spacing on either side.
Be sure to check the instructions again.
Exotic has been talked bad about alot on the board.
HMF will probably make everything right.

 

[nitrousjunkie]

Listen to Nathan

 

[Pipefighter248]

Listen to Nathan

Why cause I've installed a few in my days?

 

[Bug]

Read and re-read them a few times and the plate just looks to be wrong - I will be phone the phone with HMF first thing tomorrow

Thanks man

 

[Bansh]

Thee are 4 spacers, 2 of them are smaller then the other 2. I put the smaller ones on the right side because the left side was a tight fit between the rear passenger pegs.

 

[chrisjp]

i added 4 washers on top of the spacers inorder to get it out far enough out