I've read several posts from people trying to figure out how to put the hump on in place of the rear seat. From reading other people's responses, you would think it cost a dollar a word--they weren't very clear.
To be as brief as possible, remove the rear seat. Then you need to remove the rear hand hold for the passenger. This requires removing four bolts. The four will be obvious once you look at the grab rail.
The rear most two bolts go back in the same holes they came out of, no problem. Bolts going back in the same hole, metal on metal.
However, the front two holes have a rubber grommet that is not a ready receptacle for the bolt that came out of it (minus the grab bar). This is where your inserts (two) come in.
Below is a pic of the inserts and where they go:
I had some more pics to show all of the bolts, but I can't figure out how to get more than one pic in a post.
Anyway, there are three posts with all the pics.
<!--EDIT|FAVahalik
Reason for Edit: None given...|1125703716 -->
To be as brief as possible, remove the rear seat. Then you need to remove the rear hand hold for the passenger. This requires removing four bolts. The four will be obvious once you look at the grab rail.
The rear most two bolts go back in the same holes they came out of, no problem. Bolts going back in the same hole, metal on metal.
However, the front two holes have a rubber grommet that is not a ready receptacle for the bolt that came out of it (minus the grab bar). This is where your inserts (two) come in.
Below is a pic of the inserts and where they go:
I had some more pics to show all of the bolts, but I can't figure out how to get more than one pic in a post.
Anyway, there are three posts with all the pics.
<!--EDIT|FAVahalik
Reason for Edit: None given...|1125703716 -->
