Killswitch help

[hpeagler75]

Can anyone assist in this basic situation. I am building a Gen 2 booster from the ground up and trying to find out where this kill switch connector plug goes on to the bike have everything else connected correctly but this one connector doesn't have a home can anyone or does it anyone have a image of the location for this one connector so I can start this thing up? Harness has never been cut and everything is oem and new

 

[ottafish]

Post some pics so we can see where you're referring to.
Once we see it, should be fairly easy to sort

 

[Mythos]

If there's a connector, it would be inside the control pod I would think. I doubt if that is intended to be disconnected unless you change the kill switch. I would have assumed it was soldered inside the controls pod. Same with ignition switch unless I'm wrong.

 

[hpeagler75]

Here is my issue

 

[hpeagler75]

Everyone I spoke to say it's a connector next to the fuse box this is the only one I'm seeing but it is too narrow and it's not the same fit I feel it's missing and adapter or relay that connects to there and I can connect my kill switch and I'm just trying to reach out to people who have busa's to see if that's true this is all OEM stock wire harness stock kill switches building a busa from the floor up so everything is OEM

 

[ottafish]

So, that grey/white plug you have in the pics, normally would go to the right hand switch block on the handlebar. That's where the kill (stop/run) switch normally lives. Along with the starter button

 

[Mythos]

Based on ottafishes picture, I'd say your connector from the RH control pod is not OEM because it's black instead of gray.

There is an online supplier of many of the common Japanese motorcycle wire connectors. If your sure that black connector has the wires that are supposed to go to the grey connector on your main wiring harness, you could order one. Otherwise, order a used control pod off Ebay.

There is probably a way to remove the wires and contacts from the black plug. I wouldn't cut it. I removed a contact with wire from a female plug once using a micro screwdriver to press the tab on the contact to unlock it. Then just pull the wire out the back along with the rubber plug.

 

[ottafish]

Mines still in bits from my Gen3 frankenstien conversion. Lemme check when I get home

 

[hpeagler75]

Did the fitting change from year to year on gen 2 I bought these from this shop all things Chrome and they said these were off a o mile gen 2 think they said off a 11 I assume they didn't change my harness is a 16

 

[hpeagler75]

So, that grey/white plug you have in the pics, normally would go to the right hand switch block on the handlebar. That's where the kill (stop/run) switch normally lives. Along with the starter button

View attachment 1639416

You save my life I knew that grey connector was it thank you

 

[hpeagler75]

Contact where I got it from that is off a '11 busa and the connector changed from '13-up well anyone needs a 08-12 RH New run-stop switch will be on ebay soon under seller tasmania75

 

[Mythos]

Good sluething @ottafish

 

[hpeagler75]

I looking to buy a working used Non-splice '13-'20 busa run/stop switch. Been looking and ALL stores are on backorder and so far no luck on ebay the one I bought new is for '08-'12 doesn't fit my harness '16 does anyone know someone who is selling one?