link need ..to notch put hump

[dober]

Hi guys I can`t find the link to notch out your
hump so the grab bar can stay on.

a little sleepy and frustrated right about now,,,

thanks


Dober

 

[E4G67]

Here is one of many links on this subject: http://coastalcompucare.us/busa/id2.html Use the search engine to find information on "Hump Mod". There will be much more listed.

 

[dober]

Thanks for the link.
I tried the search with no success.Is there a trick to using
the search?I typed in "hump mod" then scrolled down
and clicked on "all open forums"It finds nothing?

what gives

Dober

 

[Schism]

Hi guys I can`t find the link to notch out your
hump so the grab bar can stay on.

a little sleepy and frustrated right about now,,,

thanks


Dober

great mod! it's convienant to swap out the rear hump for the rear seat so the "bride" can ride.

 

[CorrodedAlien]

E4G67  -  Thanks for the Pimp!!

dober, my mod takes patience, not great skill.  If you were closer I could do it for you.

Here's what I found using "hump handrail"

 

[Big Wall]

Just install the haqnd rail, then lay the hump over it to get an idea where to start cutting. Go a little at a time and you will be fine. You have to cut out more than it appears at first.

 

[clanger]

BTW when searching, make sure you click at bottom, it defaults to "this month and newer" - thats why you probly didnt get any hits

 

[dober]

Thanks guys my computer has been down for a week or so.

Dober

 

[vermie2018]

yeah it is preaty easy to do it yourself but like big wall said take your time... you only get one shot..

 

[argyle66]

Does nyone have a pic of the whel that was used on the dremel for this job or a description of it

thanks

 

[Aquaman]

Lay your hump on top, mark with a marker. Then I used a round rat-tail file to cut straight in on both ends.



then grind out the middle and make nice radiuses on the ends



hth's

 

[argyle66]

That looks very tidy and easy thanks

 

[Aquaman]

BTW, sandpaper will get you the nice looking radiuses on the outside corners... dont try to do it with the dremel.

And NO, that is not a hump.. I did it quick in mastercam

 

[argyle66]

LOL oh ok well ill give it a go