Megasquirt & other question ?

[Gixer]

Hello.
This is my first post.
My name is Alexander and I live in Croatia.
I plan on his turbo Hayabusa installed so I have a few questions about Megasquirt, and so far I have had experience only with carbs so I this is the area still unknown (GSX 1100 turbo)!
What we should all components (sensors, pick up ,....)?
I have two magnets, the Hayabusa 2000. with eight "fields" and the Hayabusa 2006.sa 34 pinout.
What is the magnet for better Megasquirt?
Even now about how to set home folder (ignition and fuel)?
I have a Garrett T34 turbo and injektore 470 cc / min, whether it is realistic to expect about 350 BHP?

Thanks a lot to the answers and sorry on my bad English!

 

[cdhoroho]

I would try and get in touch with Gsxturbo on www.turbobikes.org he knows the megasquirt very well and is working on a plug and play standalone(powered by megasquirt) (which will run my prostreet bike)

we run wasted spark with the 24-2 rotor (02+ crank rotor)
and we do change out a few sensors for other ones of better range

the turbo sounds small but ill have to go check the compressor map for it
I am using a t61 on my prostreet bike

 

[Gixer]

Thanks a lot for your reply.

Can you please clarify this story about a rotor (24-2) and (02 + crank rotor)?
That modifications to the sensors should be done?
Thanks again for your reply.

 

[cdhoroho]

sorry meant 24-1 rotor
They use it in the newer (02-07)busa
Posted via Mobile Device

 

[Gixer]

I guess that is a magnet that has a 24 PIN and one field blank?

 

[cdhoroho]

yes that rotor is the one we use

 

[Gixer]

Thanks !!!

 

[Gixer]

Thanks for your reply.
How many HP can withstand the stock parts of buse (pistons, connecting rod, crankshaft)?

 

[cdhoroho]

pistons= 400-450 (if good tune and not for extreme bursts)(best to upgrade)
rods= 300-350 (if good oiling, tune and not for extreme bursts)(best to upgrade)
crank will hold 550+ if oiling is good

 

[Gixer]

So here are the most critical point connecting rod!
It will still come to the next stage of tuning!

 

[Gixer]

Can you tell me, what should I buy with Megasquirt, counting and WB probe and controller ... ?
I bought Megasquirt II, who preferred supplier and that is the approximate price?
Thanks !!!!

 

[cdhoroho]

Can you tell me, what should I buy with Megasquirt, counting and WB probe and controller ... ?
I bought Megasquirt II, who preferred supplier and that is the approximate price?
Thanks !!!!

im sorry i dont quite understand the ?
id go hit Gsxturbo up on turbobikes.org and he can fill you in more of needed items and such

 

[Gixer]

How to solve the problem of work tachometers, FI bulb and other indicators on the control board, after the installation Megasquirt?
Is there an scheme?

Thanks !!!

 

[cdhoroho]

he has an interface board he uses that runs the gauges
Contact him at h1050d@yahoo.com
Posted via Mobile Device

 

[Gixer]

Thanks !

 

[cdhoroho]

by the way he uses the stock harness with the interface board to run the bike with the standalone
Posted via Mobile Device

 

[Gixer]

Is there a map for a Garrett T34, A / R .60, 48 compressor trim ?
On the Internet is not found!
Thanks