My rear tire alignment

[Bokey]

After looking at the price of pro tool to do this job I decided to do it myself.



I know the sting method can be used but I wanted to do it different.

I did use the sting methond to verify my results.



Home Depot boud I went. Purchased different size rubber stoppers, two metal rulers, two 1/4" steel rods.



I already had some aluminum right angle (from license plate install)



Plug holes on both sides and drill in the center.

Do the same for the rear axle.

Put rods thru stoppers (silcone grease makes them slide easier)

Take rulers with right angle brackets riveted to.

Hooked up the string method.

Verify distance on front and rear tires to sting.



Front left

Front right

Rear left

Rear right

Now I looked at the rulers on top of the rods



right side

left side

Done.

Now to work on the strips. The PP 2CTs are taking a break.

 

[LA Busa]

Nice, I guess as long as the holes in the rubber grommets are pretty close to center thats a good method!
I like it, thanks!

 

[dadofthree]

I was wondering about the center drill myself, however I will continue to use the little notches provided in the swingarm