pc3

[patton37]

Hi guys,
just got back from overseas and started toride again
and I look through the pc3 posts and could not find the answer
to my? .
So I have a pc3 and just put headers on from vance and vines with
Mt 2 bros slipons. There is no map for this setup so I was going to
use a map for a full system but it is a pc5 map will that
work with my pc3.
I intend to get a custom map but until I do I wand something as close as possible
thanks much

Steven

 

[kromdom]

Gen II (08-up) use the PC5, curious why you went with the PC3? Not sure if a PC5 map can be used on a PC3. Maybe contact Dynojet directly?

 

[Jacobs]

Gen II (08-up) use the PC5, curious why you went with the PC3? Not sure if a PC5 map can be used on a PC3. Maybe contact Dynojet directly?

When the Gen II bike came out in 2008, there was no PC5 yet. Until recently, Dynojet only listed the PC3 "available" for the 2008 but PC5 for the 09-up

 

[kromdom]

When the Gen II bike came out in 2008, there was no PC5 yet. Until recently, Dynojet only listed the PC3 "available" for the 2008 but PC5 for the 09-up

you are absolutely right ...thanks for the amplifying info (I also learned of this when I did some research for my old 08)

 

[patton37]

I understand that but can the pc5 map work with my
pc3???

Steve

 

[squale147]

try this one out...this would be best for your set up..M20-023-008.. you could also try and copy and paste the pcv map over to a pc3 but the pcv has a 15% throttle opening where the pc3 doesent..