rc component cush drive

manfromsc33

Registered
I am going to change out my cush drives on a rc component 300mm rear wheel. My question is do I just beat the the sprocket hub off and beat it back on or is it bolt on? another question is do anybody know where I can order cush drives from for a rc component wheel? thanks in advance for any help.
 
beat what off the axle not ?????????????? slide out cushing drive no beating on anything on her busa's don't like abuse ok:rulez:
 
not really beating,, but with few light taps with a rubber hammer,, just wanted to make sure that it should slide on and off and not bolt on
 
Nope, pull rear wheel and smack it with a dead-blow, if it don't come off in your hands. The tapping is when you're driving the hub onto NEW cush-rub's....
 
Back
Top