Risers

[TheEarthdog]

I am going to install a set of risers and thier documentation says I should relocate the Choke/Idle Adjust cable. Any suggestion on the cleanest route?

 

[cutter]

Disconnected it at the throttle bodies and passed it to the left of the steering stem under the tank in between the front mounting bolts.

I covered the cable with a piece of vacuum tubing cut lengthwise as it passed under the tank.

 

[TheEarthdog]

Thanks I'll give it a try.

 

[BusaCruise]

I would install the item first...then see if relocation is even necessary.
I installed the reaper version...none necessary. I will be installing a genmar this weekend, and again measure before making any relocations.

much depends on exactly what hieght you went with.

 

[7th Gear]

I would install the item first...then see if relocation is even necessary.
I installed the reaper version...none necessary.   I will be installing a genmar this weekend, and again measure before making any relocations.

much depends on exactly what hieght you went with.

Where did you buy the Reapers?

 

[BusaCruise]

Personally, I got mine off eBay...
but there is a thread on the SH.org site for the people that make them:


If you want, I can PM you when I decide which version I decide to keep....I usually only ask what I paid...and I never pay retail!....hehe

 

[7th Gear]

Personally, I got mine off eBay...
but there is a thread on the SH.org site for the people that make them:


If you want, I can PM you when I decide which version I decide to keep....I usually only ask what I paid...and I never pay retail!....hehe

Thanks, that would be great. When are you planning on selling them?