Santa was good to the BUSA

[Furball]

Well with the holidays wrapped up I am about ready to start putting all my cool stuff on the BUSA....In the pile are some clear front lenses, LED tailight (clear) with intergrated signals, swingarm spools, aluminum chain guard, and the Microns (went on a little early)...I also got a nice cover for her to sleep in when I'm not around...

Anyway, I am super excited to get all these put on and can't wait for the warm weather again...Only thing I am not familiar with is the front signals...how do you get them out...

 

[BA BUSA]

Remove the inner panel under the headlight assembly and there are two screws per lense. It's pretty tight in there but if you use a short phillips bit and a 1/4" socket with a 1/4" drive it can be done.

 

[BigBSBusa]

I removed the entire front fairing. Could have done like BA BUSA said, but it gave me greater access.

 

[Furball]

Got it, I think I'll just do the inner panel thing and get a guy at work to reach up in there and get it apart...he has very small hands and wrists compared to mine....Anytime I am trying to squeeze my hand into a tight spot and struggle for 10 minutes I get him over to help out and he'll be done in less than 1 minute....I love having small friends....thanks for the info too...wasn't quite sure what the best route was...

I didn't really want to take the whole fairing off...so the inner panel looks like the best way to go....