Stock swingarm arm length?

[BigRod1300]

What is the stock swingarm length of a GenI from center of pivot bolt to center of axle???????? Playing around in the garage on tucking the 330 up into the tail....but I have no arm to compair to see what stretch I found is the sweet spot. My measurement I like is 27-28 " center pivot to center axle.

Thanks, fast responce would be great!

 

[BigRod1300]

Pic of course...forget my invisible swingarm or method of getting the 330 into that spot for the pic

 

[slngshott]

I like where you have it mocked up at. Looks better than hanging out so far out the back. That looks about 4- 5 . Im 6-6 1/2

 

[DEMMYM]

Cant help you Brother but it looks like you have it about 5 1/2 to me

Maybe less

 

[m_ridgeway]

i have a stock gen2 arm laying on the floor i can measure if that will help?

 

[BigRod1300]

Been told now that stock is 22-1/4" so at 27-28" ( 27 in pic ) that would be at 6+ over.

Yea I still like it the way it was at 9 over but....REALY feeling this in the pic. The way I was rocking the 330 at 9 over, imagine what I can do with it short at 6 over! Prob have lots better launch at the trac too helping with weight transfure.

 

[Fastfrog007]

22.5 inches

I like where its mocked up as well