Temp senser wiring

[busa1018]

i did the temp senser relocater mod. but when i pulled out the wiring it came out of harness. don't know where they go, does it matter. can some one look at theres and discribe to me where the wires go. looking at the wiring loom and the part you press in to release would be facing you where do i put each wire the one with the solid red line down the wire is the ground i beleive. does that go to left or right side
need help now as i am in garage wiring horn and other stuff whould like it don't tonight if possible



<!--EDIT|busa1018
Reason for Edit: None given...|1149220040 -->

 

[busa1018]

oh thanks in advance

 

[TURBO1320]

Call ME,Burt 541-389-9938

 

[DAB]

Is it fixed?

 

[busa1018]

no haven't had time to call

 

[busa1018]

ok heres what happen. while i was trying to remove the the plug that's connected to the temp senser i pulled to hard and the wires pulled out of the plug. so i need to know which wire goes to what side. please tell as the plug is sitting. does the orange/yellow wire go on the left or does the orange/red go on the left. the release for the plug is facing the motor as can be seen. heres a picture of what I'm talking about



<!--EDIT|busa1018
Reason for Edit: None given...|1149296536 -->

 

[busa1018]

Thank's Burt from straight liners for all the help. I do have it backwards. now it should be fine. thanks to everyone and also Busa bill for going out of there way to check this out for me. You guys are the best

 

[Busa Bill]

just glad your getting her back on the road ,thats whats so great about this site . So with the muzzy fan mod ,Thermo fan temp sensor relocator mod, and engine ice ,you will notice difference in your temp,i did .your fan will come on sooner which is a good thing.

 

[TURBO1320]

Another happy customer,You guys are great!!! Burt

 

[busa1018]

ok now lets figure out why after all these mods for temp does the fan turn on only when the needle hits half way.
I have muzzy fan, relocated senser, and engine ice

 

[TURBO1320]

YOU PUT IT IN THE RIGHT RAD HOSE?? RIGHT???

 

[atticdog]

half way is where the fan should come on i believe, thaats where mine comes on and never gets any higher
even on the dyno last sat it never went over 1/2 line actually the fan never even came on

 

[busa1018]

this is the hose i put it on

 

[Busa Bill]

looks right to me bro. you put yours Horizontaly and mine im put on the Vertical hose comming out of the Rad. but either way It dosnt make a difference .Am I right Burt. Great Job clean Install

 

[busa1018]

thanks, have not riden yet but soon doing some small other things.