Throttle positioning spring
- Thread starter Gadget112
- Start date
Are the cables adjusted correctly?
The throttle should not have alot of tension.
The throttle should not have alot of tension.
Dustin02
Registered
Since you're in the Gen3 forum, I'm guessing that this is what you are probably looking for.
hayabusa-service.de
KPS Throttle Spring Busa Gen3 - Hayabusa Service Power-Shop
The original tension spring force of the GEN III Throttle Grip is much too forceful. With this special spring your throttle grip will be much comfortable to use As a result, the throttle grip pull is now the same to handle as the Busa Gen 1 and Gen 2. Attention !!! Installation Pictures shows...
Gadget112
Registered
You know, I had the dealership install heated handgrips as part of the sale. Maybe its something they did. If you guys don’t have an issue maybe it’s my new heated throttle.
If the throttle closes slowly or heavily, the grip may be dragging, and causing your problem.
But, if the throttle snaps closed easily, then the grip is likely installed correctly.
This is the first time I've heard of gen3's having a heavy throttle, but it's obviously an issue since there's already a lighter aftermarket spring available.
I did twist the throttle on the one gen3 that I sat on, and noticed nothing unsual about it.
Maybe there are some bikes that ended up with heavier springs, that were out of spec, who knows.
The wiring on my heated grips took some fiddling. I've never had them before. Wow. They are amazing. Sooo nice.
Oh! And my bar end throttle lock was dragging so I fiddled with that too.
Vanishing Point
Registered
Paul Wojick KPS hayabusa-service.de post on 6 may 2022 THIS
-----
New !!!! KPS Hayabusa Gen 3 Throttle cable spring - less Force to turn the throttle Grip. - Testing is over and in stock. Will be in my shop these days. OEM spring is too strong .. after in - throttle Grip force is like Busa Gen 1 . more info will come
-----
New !!!! KPS Hayabusa Gen 3 Throttle cable spring - less Force to turn the throttle Grip. - Testing is over and in stock. Will be in my shop these days. OEM spring is too strong .. after in - throttle Grip force is like Busa Gen 1 . more info will come
Vanishing Point
Registered
Paul send all parts over this planet , the gen3 TB Spring to JAPAN
Dustin02
Registered
Opened all my stuff up the other day and noticed that I accidentally ordered 2 of these springs... If you'd like, I'll cut you a deal and get it shipped out to you.
ottafish
Registered
Because it’s a pseudo ride-by-wire setup. They still have cables running down to the throttle bodies.. or the sensor to determine throttle position. Then a stepper motor, (I assume) to drive the TB plates, etc..
Gadget112
Registered
Have you tried the new spring? How do you know you have a lighter spring and not the original oem spring?
Dustin02
Registered
I haven't yet. I hope to be able to install it this weekend. Been extremely busy. I'll let you know afterwards if you'd like.
ill take it if no one else wants it, let me know total to paypal and address.
Dustin02
Registered
Will do!
paul-ash@
Registered
Hi either I have the same problem my hayabusa gen 3 where did you get the light of Spring from thanks
Dustin02
Registered
KPS Throttle Spring Busa Gen3 - Hayabusa Service Power-Shop
The original tension spring force of the GEN III Throttle Grip is much too forceful. With this special spring your throttle grip will be much comfortable to use As a result, the throttle grip pull is now the same to handle as the Busa Gen 1 and Gen 2. Attention !!! Installation Pictures shows...
Similar threads
