TPS _C00, -C00?

[03BusaBaby]

Hello there fellow biker bros, My 2003 Busa when in dealer mode is _C00 and ive read most everyone state it should be in the middle when at idle. Can I try to adjust it and it should be okay or is it the simple fact that its at the bottom to start with that the sensor is on its last leg or on its way out and im better off just buying a new one? The bike has tipped over once on me before maybe it just threw it off. The bike idles rough and turns off sometimes when im coming to a stop and its not my kickstand sensor either. From 0-10 mph it slightly stumbles but after 10mph it seems fine. spark plugs are new and has new fuel pump with new regulator as well just fyi.

Any advice or tips or anyone experience this before?
any thoughts on this issue would be greatly appreciated thanks in advance

 

[sixpack577]

Loosen the bolt and move the tps up in the groove.
It should be at C00- at idle
if the dash is lower, it is out of adjustment.
If the dash stays at the top/above center at idle, then it is out of adjustment.
The dash should be in the middle at idle, then the dash will rise if you rev the engine, then return to center at idle.

 

[03BusaBaby]

Loosen the bolt and move the tps up in the groove.
It should be at C00- at idle
if the dash is lower, it is out of adjustment.
If the dash stays at the top/above center at idle, then it is out of adjustment.
The dash should be in the middle at idle, then the dash will rise if you rev the engine, then return to center at idle.

Thank you brother I will definitely do exactly that and ill update later on how it goes.

 

[sixpack577]

Thank you brother I will definitely do exactly that and ill update later on how it goes.

Right on
Good luck with it.
It can also be a touchy adjustment, and take a few tries to get it.