1scaredwuss
Registered
i have recently lowered my bike and am wanting to put an under-tail kit on it also but am wondering if i will have any clearance issues ?any help appreciated.thanks.
Under-tail kit when lowered ?
- Thread starter 1scaredwuss
- Start date
My Busa's been lowered 2 inches in the front and rear and I have an undertail kit (Mototeck)...issues you'll have - hugger may be a problem; I don't have one and don't think I could fit one in...I also can't use a stand on the front end; not enough clearance to get the pin in under the front...
I bottom out on speedbumps if I don't stand on the pegs; if the hubby rides my Busa and hits a bump, the tire scrapes the undertail; nothing big...it wipes right off...he's about 230 lbs, so that will depend on your weight...
I bottom out on speedbumps if I don't stand on the pegs; if the hubby rides my Busa and hits a bump, the tire scrapes the undertail; nothing big...it wipes right off...he's about 230 lbs, so that will depend on your weight...
1scaredwuss
Registered
maybe i'll be o.k then,i'm lowered probably around 3"in rear,0" in front right now. i only weigh 150,i'm a runt.
The undertail should fit, but I'm sure at 3" lowered in the rear, it might scrape some when you hit a bump...it's do-able though, at least that's my guess...
Would recommend going with an undertail from The Motorhead that allows you to lower that far. Most aftermarket ones are only good to about 2-1/2".
1scaredwuss
Registered
looks like motorhead it is since that is one of the ones i was looking at.thanks.
