Wego lll help

[Bigboy Busa2]

Too late to call daytona today. My tach signal is connected to #1 injector at ecu like the instructions say. Thinking of moving connection to the injector, maybe the signal is distorted from the other wires. Especially at idol you can see its jumpy. It is connected with a quick tap connector. The settings are as the busa setup on instructions. Any ideas, thanks

 

[Bigboy Busa2]

I did raise the debounce to 4 to try to clear the signal. No effect. But on real time data the rpm arm raise from correct 1750 and shoots to about 3500. AT IDOL. So need to figure out why. Thats what it shows on graph also. And tps on real time is jumping from 0 to 6 or 7 or 3 like a bunny rabbit. Note. The bike is steady idol the while time at about 1750 rpm. thanks

 

[Bigboy Busa2]

Making a little progress. Took signal wire off coil and used injector #1 signal. Rpm reading now but a little off. I heard this was common in the busa. Still going to call daytona Monday, has to be a reason. My other bike does the same thing. The only thing I havent moved, was thinking of using a separate battery just for wego to eliminate volt surge.

 

[Bigboy Busa2]

FYI a standalone battery won't work. Must be reading volts from battery through ecu to get rpm input???? Going to ask about that too.

 

[Bigboy Busa2]

D pin and heat shrink on wires I tapped into with quick connects troubleshooting this problem. Calling tomorrow, maybe get a little understanding of whats going on

 

[Bigboy Busa2]

Coil has too much distortion. Need to use #1 injector. And adjust rpm pulse to correct the difference. Also the standalone battery wasnt grounded to the frame is why it would not work.