what is the height of the busa stock

[bradsbusa]

i lowered the front 1 3/4 and i put the dog bones from yanashiki in the middle they did not say how far it would drop the back so how do i measure the height to mke sure the front of the bike is lower than the back?

?

?

??

 

[bradsbusa]

this should be a question on a gameshow

 

[bradsbusa]

no answers everyone stumped or do thety not know thier busa

 

[dadofthree]

45.9 inches

 

[bradsbusa]

is that front back or middle

 

[bradsbusa]

trying to make sure front is down more than back

 

[dadofthree]

Answered the topic, I would have measured some point on the front to the ground and another point from the rear to the ground before and after the adjustments.

I'm not familiar with the dogbone you bought, but most will give you a 1 inch drop in the middle and a two inch drop in the next hole. Didn't they come with directions / information.

Patience grasshopper.

 

[bradsbusa]

no directions in the package ,, should have done the measurement first but too late now

 

[bradsbusa]

i need someone to measure a stock bike in front and rear then i would know

 

[dadofthree]

Did you buy A 2797

 

[bradsbusa]

yanashiki 621-0324

 

[dadofthree]

On the web site I saw dogbones for the Busa A 2797. The pic showed 3 holes. I will assume 1, 2, and 3 inches.

 

[bradsbusa]

i was just at the web sigght and u think they would tell u

 

[dadofthree]

Nope and I have read about quality issues with these products, no personal experience.

 

[BA BUSA]

(bradsbusa @ May 13 2007,08:50) no directions in the package ,,  should have done the measurement first but too late now

You could always put it back to stock height, then measure

Then lower it and measure again