What part is this?

[Jose J Ortega]

Hey guys after doing some maintenance, I saw that coolant was leaking very little from the top screw of this black case. I know the top one is the thermostat but don't know what part is this one. I check the service manual and I can find it. Need the info to order any part needed. Thank in advance

 

[c10]

Just a plastic manafold from block for coolant there is a oval O ring behind it

 

[POWERHOUSE]

That is the cylinder inlet from the water pump. There is a preformed o ring behind it, part # 17863-33E00, $3.50 at Suzuki POWERHOUSE has them in stock . . .

 

[Jose J Ortega]

That is the cylinder inlet from the water pump. There is a preformed o ring behind it, part # 17863-33E00, $3.50 at Suzuki POWERHOUSE has them in stock . . .

Thanks Frank... I will call you to order it

 

[POWERHOUSE]

how easy was that . . .

 

[Jose J Ortega]

how easy was that . . .

You are the mannnn lol!!!

 

[Jose J Ortega]

Guys I am trying to find on the service manual the Torque spec for the cylinder inlet from the water pump and I don't see it anywhere. Does any of you know it?

 

[Kiwi Rider]

"Guys I am trying to find on the service manual the Torque spec for the cylinder inlet from the water pump and I don't see it anywhere. Does any of you know it?"

10 Nm or 7 ftlb or 84 inlb

 

[ROADTOAD1340]

"Guys I am trying to find on the service manual the Torque spec for the cylinder inlet from the water pump and I don't see it anywhere. Does any of you know it?"

10 Nm or 7 ftlb or 84 inlb

Would that be water inlet connector bolt KiwiRider ?If so , that is correct 10Nm / 7ft lb , located OC-9 Gen 2 manual

 

[Kiwi Rider]

Would that be water inlet connector bolt KiwiRider ?If so , that is correct 10Nm / 7ft lb , located OC-9 Gen 2 manual

Yep, that's the bolt Jose is asking about. 10mm hex, 6 x 1 thread. Too easy.

 

[Jose J Ortega]

Yep, that's the bolt Jose is asking about. 10mm hex, 6 x 1 thread. Too easy.

Thank you both!!!