Which Wires To Run The Fuel Pump?..

[HillbillyTom]

Gen 1 (2007), which wires do I connect to, to activate the fuel pump?
The choices are..
Red w/black stripe
Black w/green "
Yellow w/red "
Black w/white "

As soon as I get the rest of the gas out of the tank I'm off to the painter.
Thanks.. Tom

 

[racerV]

I had the same problem, ended up putting the tank back on and plugging in the electrical then extending the fuel ine into a gas can. Then I cycled the kill switch for about 10 minutes until it was empty.

 

[HillbillyTom]

I got one reply on another post about the tank of the "orange" wire as positive, and the "black' as negative. I don't have an orange wire, and have 2 black wires.
Would guess the red/black stripe would more than likely be the positive, but if not.. Not too fond of the idea of creating a very high $$ paper weight.
Wonder what the need is for 4 wires to run the pump anyway.???

 

[racerV]

I got one reply on another post about the tank of the "orange" wire as positive, and the "black' as negative. I don't have an orange wire, and have 2 black wires.
Would guess the red/black stripe would more than likely be the positive, but if not.. Not too fond of the idea of creating a very high $$ paper weight.
Wonder what the need is for 4 wires to run the pump anyway.???

I think it is converted to 3 phase power for some reason. I tried using a battery charger and couldn't get it to kick on regardless of what combination I used.