Yoshi install,now a dead spot

Greygoose

Registered
Hi all-
Sorry if this has been covered before,but I can't find it if it has.Installed a pair of slip-on RS3 pipes,now have a slight "dead spot" right at about 2K when starting out.It's just as though you hit the killswitch for a microsecond,then runs fine as you accelerate.It also has seemed to make the idle a tiny bit erratic.Bike is bone stock other than the pipes.Is this normal?Anything to help it?Thanks very much.
 
Goose..

Do you have a PC on it? If so it may have to be re-mapped for the new pipes.??? Not sure though.
 
Back
Top