brembo calipers.......

delboy

God save the Queen.......
Donating Member
Registered
Has anyone ran a Busa with standard forks using 4 pot brembo caliper via 65 or 40 mm adapter plates, if so is it a big improvement
please.gif


sorry but these 6 pots have to go
deadhorse.gif


hayabusa_bracket.jpg
 
Well guys the response was overwhelming, so I ordered this
laugh.gif


busa_brembo.jpg
 
beerchug.gif


I am sure those will make a big improvement.

Happy with the stockers here. BUT, I have added a 19 x 20 Brembo master, lines, race pads and wave rotors.

Post up when you get them installed.
 
The plan is trackdays, if I can get the exhaust down to an exceptable limits and I live 1 mile from a unrestricted Autobanns.  
race.gif
beerchug.gif
 
I was going the to go that route, but the brackets were on back order, at the time! SO i went this route.

Sexs_20on_20wheels_20081.jpg
 
The plan is trackdays, if I can get the exhaust down to an exceptable limits and I live 1 mile from a unrestricted Autobanns.
race.gif
beerchug.gif
I used my Busa for several track days until I got the R1. With the addition of the 19 x 20 master, race pads, Galfer rotors and lines...2 finger braking was possible from 170mph+ at Road Atlanta with no brake fade.

Plus keep in mind I am slight larger than the average bear.......
 
Wouldn't this amount of grip cause the front tire to lockup easier? Or is the feedback better to help avoid this? I think the stock front works pretty well compared to my last bike. lol.
lurk.gif
 
Hey John...did you know there's a flower on that bike?
rofl.gif
 
rofl.gif
 
rofl.gif
 
rofl.gif
 
rofl.gif
 
rofl.gif
I know I know
corner2.png
and I can KYA too
laugh.gif
 
laugh.gif


rofl.gif


rofl.gif


rofl.gif


rofl.gif


rofl.gif


laugh.gif
 
Back
Top