another da.. power commander ques.

[nolo263]

when the ignition is on and the power commander lights up is the bar supposed to go all the way up when you go to full throttle? with the bike off ofcourse

 

[BusaFever]

Yes.

 

[nolo263]

if it doesnt what do i do? i think i remember reading about adjusting the throttle setting somewhere but i cant find it. im completly stumped when it comes to this. i cant load a map i cant do nothing. i think when i downloaded the software from powercommander.com i got the pc3 software but it doesnt give me any other. i dont know what else to do.

 

[bigjohn141]

Actually, with the key on and the bike off, the bar will disappear. you have to start it on a busa to get it to show back up. OK, to set the throttle position, connect your PC3 on the bike to your computer. start the PC application. on the right side of the application it should tell you your throttle % and rpms. go to the top of the screen and click "power commander tools". from that menu select "set throttle position". Now you sould have a screen with some numbers on it. hit reset at the bottom. Go out and twist your throttle all the way open then let off. your throttle should be set now. if you get an error message when you try to reset it, go out and start your bike (i cant remeber if it has to be running) and do it again. When you twist the throttle when it is running, do it really fast. By doing it fast, you should be able to open it all the way up and back before the bike can respond. Dont worry the computer will pick it up just fine.

 

[shenoyp]

bigjohn... I have not set the throtle position after I installed the PC on to Elenor! I just loaded up the map and left it at that. Do you think I have to set the Throtle position

Sorry for the ignorance, but why actually is it done

 

[BusaFever]

duh no.

Sorry i didnt pay attention to see you had the bike off.