Carmen got some "act right"

[nitrousjunkie]

NJ,
Where did you get those guages?

They were made by Mototek I think,but I got them off ebay.I first saw them on robopti's bike,they dont require a inverter,they use your existing back light,they look so good at night.

 

[diesel]

Cool.

 

[BusaWizard]

Stock pads are HH.

 

[frisbee]

Very Nice!!

 

[Hyper]

NJ,
Where did you get those guages?

They were made by Mototek I think,but I got them off ebay.I first saw them on robopti's bike,they dont require a inverter,they use your existing back light,they look so good at night.

gauges are sweeeeet

 

[rrookey]

NJ; bike looks Sweetttttttttt
how tough or easy was it to install your UFO undertail, I just got mine from Roaring Toys and holding off the installation until I get the 600 break-in done and the weather clears up a little, don;t want to chip it all up. I am going to install the UFO, Yoshi RS-3 complete system, and a swing arm lic. plate holder...... any ways ant tips/hints on the UFO...


Thanks Ralph

 

[nitrousjunkie]

NJ; bike looks Sweetttttttttt
how tough or easy was it to install your UFO undertail, I just got mine from Roaring Toys and holding off the installation until I get the 600 break-in done and the weather clears up a little, don;t want to chip it all up. I am going to install the UFO, Yoshi RS-3 complete system, and a swing arm lic. plate holder...... any ways ant tips/hints on the UFO...


Thanks Ralph

Use a cut-off wheel on a high speed drill to cut the stock undertail,and take your time doing the wiring,they will blink fast if you dont use the ballast resistor.

 

[pitman3321]

SWEEEEEEEEEET