NUMB: In the instructions they will tell you to remove your side fairing and horn and radiator bolt. This is not necessary.Your going to need a friend to help you to do it my way. Remove the left exhaust pipe from the left side, this is the only one that is removeable, from the right side of your bike you will see right in the middle where the pipes split to each side, theres a bracket and bolt, remove this bolt. Next remove the bolt that holds your right side exhaust on at the passenger foot peg. Now you'll need a floor jack & a long pipe for leverage. There's two bolts you need to slide in from the left side, The stopper bolt/nut and the bolt that holds the stand on. Put that pipe for leverage in the exhaust pipe that goes to your headers and with just a bit a pressure push down, this will just give enough clearance to slip in the stopper bolt.
After that with the floor jack, under the end where you removed the exhaust from the left side (same spot you put the pipe in)jack up exhaust just a hair to slip in the bolt that holds the centerstand. Your done! Put back all the other bolts you remove Follow the instructions except for the part about removing the fairing/horn/radiator part.Theres no need to do all that extra work that they say, even though after removing the left exhaust pipe the header is still the way for installation it only needs to be moved a hair up and down to slip in the required bolts.By loosing up the other bolts/brackets you can move the exhaust just enough to do the job and save time. hope I explained this to you clearly so you know what i did. Call me if unclear!
