I am in the middle of putting in a welded clutch mod and new set of OEM steels and fibers into my '05 busa, and I have a few questions.
1) How do I measure the stack height? I'd like to know what its going to be set at... do I measure it in our out of the bike? Am I shooting for straight 2.000"?
2) The manual I have is only through 03 or 04 I believe, and mine is an 05, and a few things look different. It talks about using a magnet to remove some pin (sorry I don't remember exactly what it calls it but it looks long and skinny, like some sort of alignment pin). I don't think mine has that
3) I haven't checked the part #'s on the bags yet to be sure, but the OEM steels and fiber kit I have appears to have 3 thicker steels, while the manual I have says there should be 2. Did they add another thicker steel in the 05 busas?
4) I'm also putting in some barnett springs and a clutch slave support. Where the hell does that support bracket go lol? I can't see where its supposed to be installed.
1) How do I measure the stack height? I'd like to know what its going to be set at... do I measure it in our out of the bike? Am I shooting for straight 2.000"?
2) The manual I have is only through 03 or 04 I believe, and mine is an 05, and a few things look different. It talks about using a magnet to remove some pin (sorry I don't remember exactly what it calls it but it looks long and skinny, like some sort of alignment pin). I don't think mine has that
3) I haven't checked the part #'s on the bags yet to be sure, but the OEM steels and fiber kit I have appears to have 3 thicker steels, while the manual I have says there should be 2. Did they add another thicker steel in the 05 busas?
4) I'm also putting in some barnett springs and a clutch slave support. Where the hell does that support bracket go lol? I can't see where its supposed to be installed.
