Clutch switch adjustment method

[Mr Brown]

Seen a lever kit at MPS racing that has a whole unit ready to go with built in clutch switch adjustment, looks nice and simple...

Only thing is its for a cable clutch.....sighs

Lololol
I wanted to switch to a cable clutch at one point too...
What @busakiller is saying is what I meant by adjusting stack height. You're just going to have to mess with it until it's right.

 

[AsleepAtTheTree]

Lololol
I wanted to switch to a cable clutch at one point too...
What @busakiller is saying is what I meant by adjusting stack height. You're just going to have to mess with it until it's right.

@Mr Brown Oh so you didn't add or remove actual steels and fibers to adjust stack height? You added material to the clutch lever like @busakiller did

 

[Mr Brown]

@Mr Brown Oh so you didn't add or remove actual steels and fibers to adjust stack height? You added material to the clutch lever like @busakiller did

Sorry, I misread. No, I added an extra fiber and steel to get stack height where I wanted it.

 

[busakiller]

@AsleepAtTheTree
I used jb weld. Good prep is key to it to lasting.

 

[New_busaowner]

Sorry, I misread. No, I added an extra fiber and steel to get stack height where I wanted it.

Which wire is the clutch ground im trying to install my msd launch control?

 

[Mr Brown]

Which wire is the clutch ground im trying to install my msd launch control?

I don't remember, I've slept since then...
Do a search for a wiring diagram, there are several floating around here.