DDM H.I.D.S. on my 09 1k!

EarlyBird

Donating Member
Registered
The 09 1k !

P1010001 4.jpg
 
High beam mounted HID on the left side of the head lamp assy. Wires tucked up under lower dash!

P1010015 1.jpg
 
Low beam HID mounted on the right side of hte head lamp assy. Again wires tucked up out of the way!

P1010016 1.jpg
 
A pic of the install all done! Its not like the busa where you can hide the wiring under the side panels and dash. Some of it is exposed!

P1010017 1.jpg
 
Go to my link for the install on the busa! On my 09 1k yes plug and play, but 2 things!
1# I shorted the wiring on both the busa and the 1k. Less mess with the wiring when securing it! (there harness I shortened!)

2# I had to remove the red wire and black wire for the DDM hid connector and swap them on the 09. It was aired backwards. Easy fix.... take a pick and lift the lock on the pin and remove from on side to the other!
 
Wow i do like the looks of that. Is that one ballast for hi and low?

you need 2 ballasts! one for low beam and one for high beam. i put one on each side of the head lamp assy. in the tight spot above the ram air tubes.
Posted via Mobile Device
 
u have to get two ballasts. one for each light. low and high beam n sperate ballasts.
Posted via Mobile Device
 
very nice! this is definately next on my list. and that 09 1k is sweet! and the fastest colors too:whistle:
 
Back
Top