Elbow deep in install

[Aquaman]

Looks great! How long did it take you to having the new exhaust in place like in the pic?

 

[NEA.Drew]

not too long, maybe hour and a half after everything(air box mod,muzzy fan,pair valve mod)was completed.just taking my time enjoying day off from work!!!!

 

[Cblast]

Looks great!

 

[bradsbusa]

 

[dadofthree]

very nice brother, waiting on finale.

 

[NX95240]

(NEA.Drew @ Jun. 11 2007,15:12) update pic 2

look great.were did you buy the exhaust at?

 

[Tchill2much]

looking nice bro

 

[NEA.Drew]

Ebay

 

[SnapAttack]

Waiting to install my exhaust as well. Thanks for the pics and essentials...

 

[SnapAttack]

May go without saying but be sure to double check your clearances. I heard you need at least 1/4 inch from lines and fairings. Friend sent me a video of exhaust burning up the fairing while on the dyno. Not sure if you need it with your system but heat sheilding was also recommended to me.

Of course, the only thing I know for sure is what I don't know...

 

[FastBusa]

Looks great!

 

[fasttoys1]

nIce job, tell us what your butt sez after the first test ride.

 

[JQBusa]

Looks real familiar...

 

[NEA.Drew]

anybody have any tips on bending the oil cooler line under header #1 and header #4,thanks for any tips org!

 

[SnapAttack]

IMO the correct method would be to disconnect the line and use a hand-held tubing bender to create the proper angle for clearance. Am I correct in assuming that your lines are still connected? There are several "short cuts" that will work as well but with risk. The 5 minutes it takes to disconnect these lines far out way the cost of accidental damage.

 

[RYC1966]

Ah yes, less weight + more power, not that more power is needed. Speed limit signs are suggestions, up to , but not over....must be music to you ears.
Looks good.