Installed my 3/4 reaper risers

[MC MUSTANG]

Oh looking good...looks like there is room to drop the front end a tad as well for better handling. I like it!

Yes there is... this is how i lowered my front end 3/4"

Lookin good MC!  

Hadn't even considered lowering the front... may have to look at that.

Thanks for the suggestion...

 

[GPW]

Oh looking good...looks like there is room to drop the front end a tad as well for better handling. I like it!

Yes there is... this is how i lowered my front end 3/4"

Lookin good MC!  

Hadn't even considered lowering the front... may have to look at that.

Thanks for the suggestion...

Thanks MC, I'll look for your bolt measurements and thanks for the help.

 

[frisbee]

I have the 1" and dropped mine . I like it alot. get those plugs and use them for the frame holes.

 

[CAT3]

MC, do you recall what diameter the dual stem stand is? I guess I could measure, but if you know, I prefer the tried and true method... Now I need to look into that intercom setup

 

[MC MUSTANG]

MC, do you recall what diameter the dual stem stand is?  I guess I could measure, but if you know, I prefer the tried and true method...  Now I need to look into that intercom setup

13mm ... now I just gotta get the dang bolt length for GPW...
Going out to install my pazzos now...

 

[bacharles]

 

[MC MUSTANG]

Oh looking good...looks like there is room to drop the front end a tad as well for better handling. I like it!

Yes there is... this is how i lowered my front end 3/4"

Lookin good MC!  

Hadn't even considered lowering the front... may have to look at that.

Thanks for the suggestion...

Thanks MC,  I'll look for your bolt measurements and thanks for the help.

GPW - I have a couple of numbers for you -
Bolt is three and 1/2 (3.5) inches long
3.1 below the head

Hope that helps.

 

[MC MUSTANG]

Put the Pazzos on... that took all of 4 minutes...

 

[GPW]

Oh looking good...looks like there is room to drop the front end a tad as well for better handling. I like it!

Yes there is... this is how i lowered my front end 3/4"

Lookin good MC!  

Hadn't even considered lowering the front... may have to look at that.

Thanks for the suggestion...

Thanks MC,  I'll look for your bolt measurements and thanks for the help.

GPW - I have a couple of numbers for you -
Bolt is three and 1/2 (3.5) inches long
3.1 below the head

Hope that helps.

Thanks I'll convert that to MM for my purposes thanks a million...

 

[MC MUSTANG]

Oh looking good...looks like there is room to drop the front end a tad as well for better handling. I like it!

Yes there is... this is how i lowered my front end 3/4"

Lookin good MC!  

Hadn't even considered lowering the front... may have to look at that.

Thanks for the suggestion...

Thanks MC,  I'll look for your bolt measurements and thanks for the help.

GPW - I have a couple of numbers for you -
Bolt is three and 1/2 (3.5) inches long
3.1 below the head

Hope that helps.

Thanks I'll convert that to MM for my purposes thanks a million...

No problem man - glad I could help - even if only a little!

 

[BigGeorge]

Diggin the whole setup Shawn... sweet!