Mounting GiPro above gauges??

[mikeh]

I got mine mounted on the side of the clutch master for the time being, but may look at moving it once I've got a double bubble.



Mike

 

[Aquaman]

Joseph, you never stop amazing me!!

 

[SANDFLEA85]

made a "L" bracket with a piece of aluminum,screwed it in to top of dash and then velcro'd GIPRO to it

 

[SANDFLEA85]

im working on another mounting method, its in the works now, i think once i get it finished, brendan could make these things. heres a picture of it on my vrod, i think it will still fit above the dash and mount to the bar behind the gauges.  this picture was with the acumen, the one i am having designed now is for the gi pro

is there access to the bottom to change maps?

 

[first vr4]

made a "L" bracket with a piece of aluminum,screwed it in to top of dash and then velcro'd GIPRO to it

That's what I was thinking of doing. How did you run the wire thru the bracket?

 

[thepushercg]

AM -->

1290448[/ATTACH] AM]
im working on another mounting method, its in the works now, i think once i get it finished, brendan could make these things. heres a picture of it on my vrod, i think it will still fit above the dash and mount to the bar behind the gauges.  this picture was with the acumen, the one i am having designed now is for the gi pro

is there access to the bottom to change maps?

on this one, its a easy in and out, remove the two front allens and pull it out of the housing gives you full access, i prefer this anyday over mounting inside mirrors where you would not have access to it.

what your asking i dont think would be a problem if you can find dead center where the pin is to drill a hole in the housing where you could push the pin.

 

[SANDFLEA85]

made a "L" bracket with a piece of aluminum,screwed it in to top of dash and then velcro'd GIPRO to it

That's what I was thinking of doing. How did you run the wire thru the bracket?

just ran it behind and over the gauge cluster,cant see it!