On the agenda for today

[Rongotti]

1) Valve check
2) Replace the rear hub
3) (Try to) install the Roadlock
4) Clean up the battery terminal
5) Figure out some kind of quick release pins for the front seat

If I can get the first two accomplished I will be happy
wish me luck!

 

[Irish]

And u need to change ur SIG

 

[Twist The Throttle]

First two = Big Day!

 

[Rongotti]

Ok so a few questions

Why would intake air temp sensor be removed from the airbox? I am just trying to figure if I need to put it back or not
Posted via Mobile Device

 

[racerV]

Ok so a few questions

Why would intake air temp sensor be removed from the airbox? I am just trying to figure if I need to put it back or not
Posted via Mobile Device

If it has a Power commander, it may not be necessary. You also have a big bore kit so the air / fuel compensation vs the computer are going to be different.

 

[Rongotti]

Thanks RV, valve check completed and everything was perfect!
Posted via Mobile Device

 

[dadofthree]

Do a search for the quick release pins. Do the fuel tank while you're at it.

 

[x-d-x]

Nothing like a good project day!! hope it went smoothly man

 

[Rongotti]

Sonny has some quick release pins on the fuel tank for me they are super sweet. Now I need some for that damn corbin seat
Posted via Mobile Device

 

[Rongotti]

Oh yea........ the rear stand came out from under the bike, great catch on my part ??? Apparently the clip was too far back on the swing arm.
Posted via Mobile Device

 

[GsxrBots]

Oh yea........ the rear stand came out from under the bike, great catch on my part ??? Apparently the clip was too far back on the swing arm.
Posted via Mobile Device

That right there is reason alone to buy spools..