Oncycles ucs1 universal stand

[bacharles]

 

[frisbee]

I don't understand the 2 wheel on one side and 1 on the other. Is it so you can roll it to the bike while its leaning and just pick it up ? Or do you need to stand the bike straight first?

 

[gsferrari]

i'm just not getting how it goes up and sits the bike level when it is crooked without a bike on it...

I need a stand like this too because i cant get my bike up on the stand i have now without the help of someone else!

It is not crooked

The left side has one wheel right under the load bearing point. The right side has two wheels attached to a T section under the load bearing point.

Thats why it looks crooked in that picture.

See this picture to understand what I am talking about...

 

[gsferrari]

I don't understand the 2 wheel on one side and 1 on the other. Is it so you can roll it to the bike while its leaning and just pick it up ? Or do you need to stand the bike straight first?

You cannot lower the bar easily if you have two wheels on BOTH sides. Having only one wheel makes it easier to puch the bar down. This moves the wheel forward therefore lifting up the left rear of the bike before the right rear falls into the holding pin.

If both sides had two wheels...you would need serious back and ab muscles to get the job done.

 

[Professor]

Bump!